Logo

U3169 Engine Trouble Code

Meaning of U3169 engine trouble code is a kind of network trouble code and theoretically you can drive for a few weeks or even months with a broken MAF sensor. You will notice a decrease in gas mileage and over time the car will eventually start stalling a lot. At a shop, the replacement cost is between $240-$400 depending on the car, but that's usually the cost of parts because the labor is relatively simple.

U3169 Fault Symptoms :

  1. Check engine light comes on
  2. Engine stalling or misfiring
  3. Engine performance issues
  4. Car not starting
If one of these reasons for U3169 code is occuring now you should check U3169 repair processes.
Now don't ask yourself; What should you do with U3169 code ?
The solution is here :

U3169 Possible Solution:

U3169 Engine

Gasoline engines use spark plugs to cause an explosion of fuel within the cylinder. In a properly timed engine, this explosion occurs at the proper moment to send the piston to the bottom of the cylinder and provide power to the drive shaft. If the plug wires are out of sequence, the explosion occurs at the wrong time. The improper timing of the explosion sometimes pushes the cylinder the wrong direction or interferes with the turning of the crank. As a result, the engine stutters or backfires, if it runs at all.

U3169 Code Meaning :

U 3 1 6 9
OBD-II Diagnostic Network (U) Trouble Code For Engine Ignition System Or Misfire Fuel Rail/System Pressure - Too High Cylinder 4 Contribution/Balance Fault Reverse Input Circuit

The poor running symptoms are consistent with a MAP sensor malfunction. In addition, in some cases, a bad MAP sensor will not throw a code. Again, the ELD code likely represents a separate wiring issue.

U3169 OBD-II Diagnostic Network (U) Trouble Code Description

U3169 engine trouble code is about Reverse Input Circuit.

Main reason For U3169 Code

The reason of U3169 OBD-II Engine Trouble Code is Fuel Rail/System Pressure - Too High.

U3169 code on vehicles with electronically controlled automatic transmissions, the 3-4 shift solenoid is responsible for actuating the hydraulic circuits to activate clutches or bands that change gears inside the automatic transmission.